Nozzle elements

NOZZLE ELEMENTS
Nozzle elements are produced with high precision and a high surface effect to satisfy requirements for fast and safe heating.
Nozzle elements for mounting on nozzles for spraying machines are available in stock.
During production, the element is pressed together under very high pressure, which gives high insulation resistance, good heat transfer without air gaps in the element and a smooth surface for optimal and even heat transfer from the entire surface of the element.
The element is completely sealed to prevent melted plastic, oil, gas etc. pulls in.
Spesialutførelse
Backer har også dyseelementer i spesialutførelse for spesielt korrosive miljøer, som sprøytestøping av detaljer i PVC-plast. Disse gir høyere temperatur og en overflateeffekt på 7 W/cm². Alternativ tilkopling: radial, vinklet 0°, vinklet 30°, tangential 0°
Montering og vedlikehold
Bruk en 4 mm unbrakonøkkel. Det er viktig at dyseelementet er montert slik at det ikke er noen luftspalter mellom elementet og f.eks. munnstykket på en sprøytestøpemaskin. Elementet skal etterstrammes etter første oppvarming.
Unngå å bøye tilkoplingskabelen nær elementet.
Plastmateriale på elementoverflaten kan fjernes ved oppvarming til smeltepunktet.
Unngå slag på elementet og vær forsiktig når du skal fjerne plast.
Technical data
Material
Connection
Voltage
Surface loading
Tensional stability
Related products

Backer also has nozzle elements in special designs for particularly corrosive environments, such as injection molding of details in PVC plastic. These allow a higher temperature and surface effect of 7 W/cm².