We are closed for summer holidays from week 28 - 31. We are back on August 4th. Have a lovely summer!

+47 62 82 88 28 | marked@norskebacker.no |

ACR miniPRO Hot Bonder

The ACR MINIPRO is a single-zone hot binder for controlling localized heat and vacuum sources to cure composite materials for production and repair applications, including mass removal and curing of resins, prepregs, adhesives, fibers and more. This lightweight, portable binder features a full-color touchscreen and a keypad interface that provides an easy-to-use menu for quick three-step programming. The ACR MINIPRO is an ideal composite curing control tool for the aerospace, marine, automotive and construction industries.

Built-in vacuum venturi
20 or 30 amp output with 10 thermocouple sensors
Easy data transfer and analysis after curing via USB drive
3 year warranty

I would like more information
Please leave your contact information in the form below, and we will get in touch with you!

Easiest to use, fully loaded hot tie under 8 kg
Full-color touchscreen interface
Built-in vacuum venturi
20 or 30 amps output
10 thermocouple sensors
Audible and visual alarms for high and low temperature/vacuum limits
Fast and easy data transfer with USB drive

Application:

Aircraft repair
Crediting field repair
Repairing wind turbine blades - even up in the tower
A wide variety of industries and applications: sporting goods, automotive, marine, recreational vehicles, racing and more

In general

Single zone
8.4″ (213 mm) touchscreen with user-friendly interface
USB port for data transfer (USB flash drive included)
Input with RCD
Audio and visual alarms for high and low temperature/vacuum limits
Digital data logger
Compact size of 41.75 cm L x 33.34 cm D x 17.30 cm D
Weighs less than 8 kg

Temperature control

Curing up to 760 °C
10 inputs for J-type thermocouple sensors
Accuracy: ±1,67 °C
Monitors all thermocouples for alarms
Digital data logger: records hardening status in real time, including program parameters

Software

Fast 3-step programming: Stores up to 30 programs on hot binding unit
Easy to follow Menu options
Program curing with up to three soaks
Quick and easy data entry: Uses simple drop-down menus and a familiar QWERTY keyboard interface
Secure: Multiple levels of password protection
Upgradeable
Multi-tasking: Perform multiple operations at the same time
Preserves the history of the last 12 hardenings
Customized post-curing analysis: Data logging intervals 1 to 99 minutes
Multi-language support: English, German, Russian, Chinese (Mandarin)

Electricity

Input voltage: 100-130 VAC, 200-240 VAC
Protected with earth leakage circuit breaker
Voltage fluctuations in the mains supply of up to ±10 % of nominal voltage
Transient overvoltages typically found on a Category II power source: e.g. a lighting circuit
Frequency: 50-60 Hz
20 amps capacity (30 amps optional)
Output wire connector: NEMA L15-30R

vacuum

Vacuum venturi (requires compressed air)
Pressure: Up to 28 inches Hg (13.8 PSI)
Possibility of manually adjusting the pressure

Environment

Intended for use in dry environments. Do not expose to splashes.
Altitude up to 2000 m (6562 ft)
Storage temperature range: -20 to 60 °C (-4 to 140 °F)
Operating temperature range: 5 to 40 °C (41 to 104 °F)
Maximum relative humidity: 80 % for temperatures up to 31°C (88°F), decreasing linearly to 50 % relative to humidity at 40°C (104°F)
Contamination level 2 (normally only non-conductive contamination occurs, but a temporary conductivity caused by condensation must be expected)